水泥攪拌車儲水罐加水操作步驟
一、控制好儲水罐的氣壓經常緊固各個管接頭
1、 Control the air pressure of the water storage tank and tighten all pipe joints frequently
水泥攪拌車罐體內應該打進多少的氣壓，這個在出廠的時候已經設定好，不需自己調節。如果遇上特殊情況非要調節，建議壓力控制在3.5Mpa左右，壓力太大容易爆管。另外，新的水泥攪拌車以及日常使用中，要對管路接口的地方隨時緊固，防落。
How much air pressure should be injected into the tank of the cement mixer? This has been set at the time of delivery and does not need to be adjusted by yourself. If it is necessary to adjust in case of special circumstances, it is recommended to control the pressure at about 3.5Mpa. If the pressure is too high, it is easy to burst the pipe. In addition, in the new cement mixer and daily use, the pipeline interface shall be fastened at any time to prevent falling off.
二、水泥攪拌車罐車加水步驟
2、 Steps for adding water to cement mixer tanker
每種水泥攪拌車罐車加水處的布置都大同小異，一般都是水罐排氣——加滿水——關閉加水閥；在不用的情況下，需要將撥桿的位置放在中間。
The arrangement of the water filling place of each cement mixer tanker is similar. Generally, the water tank is vented - filled with water - and the water filling valve is closed; When not in use, you need to put the position of the paddle in the middle.
三、冬季排盡水泥攪拌車儲水罐內的余水
3、 Drain the remaining water in the water storage tank of cement mixer truck in winter
在冬季，尤其北方的用戶每天收車之后應該排盡水泥攪拌車水罐內和水管中的水，并在水管打入壓縮空氣吹盡各個管路中殘留的水，防止因為結冰造成管路凍裂。
In winter, especially in the north, users should drain the water in the water tank of the cement mixer and the water pipe after receiving the vehicle every day, and inject compressed air into the water pipe to blow out the residual water in each pipeline to prevent the pipeline from freezing and cracking due to icing.
以上就是今天小編給大家提供的精彩內容，更多的精彩內容請點擊進入我們的網站：混凝土自上料攪拌車廠家http://www.xiaoplaoshi.cn
The above is the wonderful content provided by Xiaobian today. For more wonderful content, please click to enter our official website: concrete self loading mixer manufacturer http://www.xiaoplaoshi.cn
下一篇：攪拌車如何更換液壓油？上一篇：混凝土自上料攪拌車氣缸常見的故障有哪些？
