攪拌車磨合期期間保養的基本要求與注意
剛買回來新的攪拌車,磨合期的保養非常重要,磨合期保養做好了,會延長攪拌車使用壽命。好的開始,是成功的一半。新車在磨合期間內,做好各方面小細節的保養,不要覺得是一些小毛病就不注意。其實混凝土自上料攪拌車的小毛病也要及時保養,下面混凝土自上料攪拌車廠家為您講解。
The maintenance during the running-in period is very important for the newly purchased mixer truck. If the maintenance during the running-in period is completed, the service life of the mixer truck will be extended. A good start is half the battle. During the running-in period of the new car, do a good job of maintenance in all aspects and details. Don't think it's just a few small problems and don't pay attention to them. In fact, the small defects of the concrete self-loading mixer should also be maintained in time. The manufacturer of the concrete self-loading mixer will explain to you.
磨合期期間保養的基本要求
Basic requirements for maintenance during running-in period
一、減小車輛所運東西的質量:翅汽車在磨合期內裝載量不能超過額定載荷的75%。新車在裝載時應低于規定的載重或人數,更不能超載,因為超載會加重發動機、變速器、傳動系統、懸掛系統等部件的負擔,加重磨損，對車輛造成損害。
1、 Reduce the mass of the goods carried by the vehicle: the load of the wing vehicle during the running-in period shall not exceed 75% of the rated load. When loading a new car, it should be lower than the specified load or number of people, let alone overloading, because overloading will increase the burden of engine, transmission, transmission system, suspension system and other components, increase wear, and cause damage to the vehicle.
二、使用質量良好的潤滑油:選擇低黏度和優良潤滑油,能使摩擦表面得到良好的潤滑,減緩機件磨損。
2、 Use high-quality lubricating oil: select low viscosity and excellent lubricating oil, which can make the friction surface well lubricated and reduce the wear of machine parts.
磨合期保養應該注意的一些事項
Precautions for maintenance during running-in period
一、先對車子進行預熱,冷啟動時,好等水溫預熱到40度以上再起步。攪拌車起步時應輕踩慢抬離合器和加速踏板,并選擇良好的路面行駛。涼車時候也不要猛踩油門]。
1、 Warm up the car first. When starting cold, wait for the water temperature to warm up to above 40 degrees before starting. When the mixer starts, gently step on the clutch and accelerator pedal, and select a good road to drive. Don't step on the accelerator when the car is cold].
二、控制好攪拌車的速度,處于磨合期的攪拌車,一定要控制好駕車的速度,不能速度太高,時速好控制在50--80/時。在開過1500后可逐漸把轉速和車速提高到車輛允許的高速度,而且不要用力踩油門，以保證活塞、汽缸及其它-些重要的部件在緩和的狀態下提高負荷。
2、 Control the speed of the mixing truck. For the mixing truck in the running-in period, it is necessary to control the driving speed. The speed should not be too high. The speed should be controlled at 50-80 km/h. After driving 1500 kilometers, the speed and speed can be gradually increased to the allowable high speed of the vehicle, and do not step on the accelerator hard to ensure that the piston, cylinder and other important components increase the load in a relaxed state.
三、開車時檔位要勤換,不要長時間使用一個擋位,起步時先掛低檔,然后逐步換為高擋,循序漸進地行駛。低擋高速，高擋低速的現象一定要避免,這樣會減小發動機的使用壽命。
3、 When driving, shift gears frequently. Do not use one gear for a long time. When starting, first shift to low gear, then gradually shift to high gear, and drive gradually. The phenomenon of low gear high speed and high gear low speed must be avoided, which will reduce the service life of the engine.
四、制動分離合,小型攪拌車在制動的時候,要先踏下離合踏板,使齒輪嚙合松開后再踩制動踏板。這樣可以減少新車發動機、制動系統、底盤的中擊損傷。但是這種"先離后剎”的方法是不符合駕車規范的,它限于處于磨合時期的車輛。
4、 The brake is separated and engaged. When the small mixer is braking, press the clutch pedal first to release the gear engagement and then press the brake pedal. This can reduce the impact damage of the engine, brake system and chassis of the new car. However, this method of "leaving first and braking later" is not in line with the driving regulations. It is limited to vehicles in the run-in period.
在度過磨合期后,從離合器的保養方面,我們還是應該"先剎后離”。我們也聽到過不少的新手,在開車的初期總是把腳放在離合器上,剎車前要先把踏板踏下去。有的人還為了換擋的方便'腳不離板。的確。對新手來說,這樣開車可以把車開得更平穩些,但對離合器的磨損可不小。
After the running-in period, we should still "brake first and then leave" in terms of clutch maintenance. We have also heard that many novices always put their feet on the clutch at the beginning of driving, and put the pedal down before braking. Some people also keep their feet on the pedal for the convenience of gear shifting. Indeed, for novices, driving in this way can drive the car more smoothly, but the wear on the clutch is not small.
不論是老司機還是新司機,攪拌車在磨期的各種保養一定要注意。不要因小失大,磨合期的一些正確習慣都是為了車輛以后更好的為我們服務。磨合期做好,以后攪拌車會更省油而且開車時也特別輕松。更多相關事項就來我們網站http://www.xiaoplaoshi.cn咨詢吧！
Both old and new drivers must pay attention to the various maintenance of the mixer during the grinding period. Don't lose everything. Some of the correct habits in the run-in period are for the vehicle to serve us better in the future. The running-in period should be done well, and the mixer will save more fuel in the future, and it will be especially easy to drive. Come to our website for more relevant matters http://www.xiaoplaoshi.cn Ask!
